The storage of carbon spiral tube equipment is a very troublesome problem, because sometimes the product is damaged due to improper storage. The strength of the carbon spiral pipe equipment is generally higher than that of the straight seam welded pipe. It is possible to produce a welded pipe with a large diameter by using a narrow blank, and it is also possible to produce a welded pipe having a different pipe diameter with a blank of the same width. However, compared with straight pipe of the same length, the length of the weld is increased by 40% to 100%, and the production speed is low.
The outer diameter of the tube of the carbon spiral tube apparatus is indicated by the letter D, followed by the standard and wall thickness of the outer diameter. There must be a certain passage between the 垛 and 垛 of the carbon spiral pipe equipment. The width of the viewing passage is generally about 0.5 meters. The width of the access passage depends on the size of the material and the conveying machinery, generally 1.5 to 2 meters. The stacking height of the spiral steel pipe, the work of the staff does not exceed 1.2 meters, the mechanical work does not exceed 1.5 meters, and the width of the ship does not exceed 2.5 meters. For example, if the carbon spiral pipe equipment is stacked in the open air, it is necessary to avoid wooden mats or stones under the spiral steel pipe, and the kneading surface should be slightly inclined to facilitate drainage, and pay attention to whether the steel pipe is placed straight or not, and avoid the bent steel deformation of the steel pipe. According to the detailed situation, if the warehouse is on the cement floor of the Rising Sun, the height of the pad is 0.1 m; if it is mud, it must be 0.2 to 0.5 m high. The carbon spiral pipe equipment is equipped with a special single screw extruder for polyolefin, which has the characteristics of high efficiency extrusion and high efficiency plasticization. The special separation type mixing screw and the spiral structure head have reasonable flow passage and smooth inner and outer walls of the pipe. The production range of carbon spiral pipe equipment is 50-200mm, and the production speed is as high as 1.5-5m/min. Efficient and flexible, suitable for the supply of polyolefin materials, extrusion of multi-layer spiral reinforced tubes of different specifications, more than 80% of recycled materials can be used. The optimized design of the copper spiral sizing sleeve has a pre-cooling device and a powerful vacuum suction device at the inlet end for efficient extrusion of the pipe. Specially designed spray cooling water tank, the cabinet is made of stainless steel. Efficient spray pumps and special sprinklers provide efficient spray cooling. Advanced coextrusion technology and maximum use of recycled materials to reduce costs.